Uživatelská Příručka Audiovox Televizní Kabely Tv Cables [1/11 Stránek]

Audiovox televizní kabely TV Cables

INSTALLATION PROCEDURES

~NG CABLE (continued) I

2. Attach the Bead CbaiD to the Two Bead

Connector; Secure beadS by folding down

the metal tabs. The following parts will be

used when installed properly:

Two Bead ConDector, Bead Cb~D,

Bead CbaiD CoDnector, and Bead

CbaiD CoDDector Cover. (Figure 16)

3. Remove clip or pin which retains throttle cable

(and washer if provided) and install Two Bead

Connector on the same side of throttle cable as

the Cable Assembly will be anchored. This is

necessary so that Cable Asaeinbly and throttle

cable will not cross.

4. The Two Bead may need to be bent so that it

clears the throttle cable. (Figure 17) Also, the

4" Tie Strap can be used to hold the Two

Bead Connector to the sleeve of the throttle

cable. (Figure 17)

NOTE: After the Cable Assembly has been

Attached, manually move the throttle to assure

the Cable Assembly does not hang up on any

part of the vehi~le.

1, GM. Ford. and Chrvsler Throttle

Usin~THRQ1TLE CLIP WlTHCABLE

I. Some OM, Ford. and Cbrysler vehicles

have an attachment stud qn ~e throttle pulley .

2. Slide a Bead Chain Connector Cover over

the cruise cable, then attach the Bead Chain

Connector to the cable. Attac~ the Throttle

Clip with Cable to the Bead Chain Connector

And slide the Connector Cover over the Bead

Chain Connector. (Figure 18)

3. Slide the Throttle Clip over the throttle pulley

attachment stud. Push Throttle Clip onto the stud

until it snaps firmly onto the Stud.

Throttle Clip with C-able

FIGURE 18

Form #4313, Page 13